Qos - D-Link DSL-2544N User Manual

Section 3 – Web Configuration
Note: The settings only apply when the firewall is enabled.
IP v6 Filtering
The configuration on IP v6 Filtering is similar to that on IP v4 Filtering. For the parameters description, please refer to IP v4 Filtering.

QoS

Choose ADVANCED > QoS. The QoS Configuration page shown in the figure
appears on the right.
The following table describes the parameters of this page.
Field
QOS
Direction
Queue Enable
Bandwidth
Discipline
WRR weight
Enable DSCP
Mark
Enable 802.1P
Mark
After setting the parameters, click Save to save the QOS configuration.
In this page, click Add Rule. The page shown in the figure appears on the right.
You can configure QoS queue rule.
D-Link DSL-2544N User Manual
Description
Choose the box to enable the QOS.
Choose Upstream queue or Downstream queue.
Tick in the box to enable queue.
Total bandwidth for upstream flow
Discipline type of QOS
When Discipline was chosen to WRR, you can
config WRR
You may tick in the box to permit DSCP Mark.
You may tick in the box to permit 802.1P Mark.
41