Table of Contents
Advertisement
installation & connection
Communications Cable
For the camera to communicate with the controller, a RS-485/422 communications line is
required.
J
A 30m or shorter length is recommended for the connection.
The communication cable is not enclosed with the camera.
Connecting the installation monitor
Connect the cable to the camera's rear video output terminal and the installation monitor's
video input terminal.
The wiring varies depending on your monitor type and peripheral devices; please refer to the user manual
for each device.
Please make sure the monitor and camera are turned off when connecting them.
You can set the video output type to either NTSC or PAL. (page 66)
J
This product is a network camera that transfers video over a network; the video output terminal is
used to set the imaging range of the camera at installation.
Using the terminal for monitoring purposes may cause problems such as degradation in video
quality.
30_ installation & connection
Monitor
Advertisement
Table of Contents
