Computer Input; Input Source Selection - Sanyo PLC-XE31 Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Select either Computer 1 or Computer 2 by pressing the
COMPUTER button on the remote control.
Before using COMPUTER button, select the correct input
source through Menu operation as described below.
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Press the Point
framed pointer to the Input Menu icon.
2
Press the Point
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button.
✔
Note:
• Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out. (p. 45)
• Computer 2 (COMPUTER IN 2 / MONITOR OUT) can accept only
RGB signal.
26
buttons to move the red
7 8
ed buttons to move the red arrow
Remote Control
COMPUTER button
COMPUTER button
Input Menu icon
Input Menu
Move the pointer (red
arrow) to Computer 1
and press the SELECT
button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Computer 1
Computer 2