Sanyo PLC-XE31 Owner's Manual page 59

Some displays are not seen
during the operation.
PIN code dialog box appears at start-up.
Computer 2 cannot be selected.
The Terminal function cannot be selected. –The Terminal function cannot be selected after Computer 2 is
The Remote Control does not work.
Cooling fans are still running after
the AC plug is disconnected.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Give the model number and explain about the problem. We will advise you
how to obtain service.
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Pixelworks ICs used.
–Check the Display function. (See p. 42.)
–PIN code lock is being set. Enter a PIN code (1234 or
numbers you have set). (See pp. 19, 47, 48.)
–Select Computer 2 at the Terminal function. (See p. 45.)
selected. Select other input source such as Computer 1 or
Video with the COMPUTER button or the VIDEO button on
the remote control so that the Terminal function can be
selected.
–Check the batteries.
–Make sure no obstruction is between the projector and the
remote control.
–Make sure you are not too far from the projector when using
the remote control. Maximum operating range is 16.4' (5m).
–Make sure the code of the remote control is conformed to
the projector. (See p. 46.)
–This is normal condition. Fans keep running for a certain time
even after disconnecting the AC plug.
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
Appendix
59