Table of Contents
Advertisement
Erase a Program
Action ·
1.
Record enable.
2.
Use the Page button to select the page the
Scene you wish to erase is on.
3.
Press and hold the Edit button & tap the
Flash button (13-24) twice of the Scene you
wish to erase.
4.
Release the 2 buttons. The LED for the
corresponding program should light,
indicating that it has been selected.
5.
Press the Delete button. All LEDs should
light, indicating the program is erased.
Erase all Scenes
Action ·
1.
Record enable
2.
Press and hold RECORD.
3.
While holding Record button, tap the flash
buttons in the following sequence: 1-3-2-3.
Release the Record button.
4.
All LEDs should light, indicating all
programs have been erased.
5.
Press and hold RECORD & REC EXIT to
exit the mode.
Warning: this will reset the controller to its factory defaults. This will erase all programs and settings.
Record Clear
Action ·
1.
Record enable.
2.
Record a scene with 1 or more steps.
3.
If you are not satisfied with the scene, you
may press and hold the Record button &
tap the Page/REC CLR button. All LEDs will
flash, indicating the scenes have been
cleared.
Stage Designer™ 50
¥
Notes
¥
Notes
You must be in Record mode to Reset the
controller.
The LED over the Record button will light,
indicating the Record mode operation.
¥
Notes
All scenes stored in the temporary memory of the
controller will be erased by this process.
This process will not affect the scenes already
programmed into a Scene fader.
11
Rev. 9
Advertisement
Table of Contents
