Table of Contents
Advertisement
Configuration
(Standalone)
Automatic
Programs
Auto-Program
Speed
Sound-Active
Mode
Sound Sensitivity
Preset Color
Mode
Custom Color
Mixing
Dimmer Speed
SlimPAR PRO Q USB User Manual Rev. 3
Set the product in one of the standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To run the SlimPAR PRO Q USB in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select an auto program (P1–4).
4.
Press <ENTER>.
To change the auto-program speed on the SlimPAR PRO Q USB, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the program speed (S--1–100).
3.
Press <ENTER>. The product will return to the last selected mode.
To run the SlimPAR PRO Q USB in sound-active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select a sound-active program (Snd1 or Snd2).
4.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To change the sound sensitivity on the SlimPAR PRO Q USB, follow the instructions
below:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the sound sensitivity (u--0–100).
3.
Press <ENTER>. The product will return to the last selected mode.
To run the SlimPAR PRO Q USB in preset color mode, follow the instructions below:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select a static color (C1–19).
4.
Press <ENTER>.
To custom mix a static color, follow the instructions below:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER> and one of the following will show on the display:
·
r_ _ _ (red)
·
g_ _ _ (green)
·
b_ _ _ (blue)
·
A_ _ _ (amber)
3.
Press <ENTER> to cycle through the color settings.
4.
When the desired color shows on the display, use <UP> or <DOWN> to increase or
decrease the color value.
5.
Repeat steps 3 and 4 until the product outputs as desired.
To change dimmer speed on the SlimPAR PRO Q USB, do the following:
1.
Press <MENU> repeatedly until dIM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select:
·
dIM1 (fast)
·
dIM2 (medium)
·
dIM3 (slow)
or
·
OFF.
4.
Press <ENTER>.
Page 13 of 19
Advertisement
Table of Contents
