Radio Shack PRO-433 Quick Start Manual page 36

Special Features
2
. Connect the interface cable into each scanner's PC/IF port.
3
. While you press and hold E/PGM on both scanners, turn on
both scanners.
4
. Determine the scanner which has the frequency data that you
want to transfer. This one must be set up as the First Unit, and
the other must be set as the Clone Unit
5
. Press E/PGM on the First Unit and then the Clone unit. The
First Unit checks whether the Clone unit is connected correctly.
When a First Unit receives the response from the Clone unit,
the data transfer starts. During data transfer, SND and REC
fl ashes.
6
. When the data transfer is completed, donE appears. If the data
transfer is not successful, Error appears.
7
. After the clone operation is complete, remove the cable, turn
both units off and then on again.
36