Section 4: Programmable Features - Ultra Start MCS-100 Owner's Manual

MCS-100
Note: If you hear three chirp sounds, the system has been triggered and the alarm was activated while you were
away from the vehicle. Please refer to following chart. This diagnostic report will turn off when ignition
switch is turned on.
Shock Sensor
Optional Input Trigger (Mercury Switch, Microwave & etc)
3.3 Personal Protection Alarm (EMERGENCY PANIC)
Press and hold down RF transmitter button #1 for approximately three seconds.
Personal Panic alarm is activated and siren sounds and lights flash for one (1) minute.
Press and release any RF transmitter button to cancel the panic alarm.
3.4 Motorcyle Finder Mode
Press and hold down RF transmitter button #3 (#1+#2) for approximately three seconds.
Lights flash for one (1) minute.
Press and release any RF transmitter button to cancel the Motorcycle finder mode.

SECTION 4: PROGRAMMABLE FEATURES

Programming Function
Code Program Method 1
Code Program Method 2
(4.1)
Permanent Siren Chirp Disable
Permanent Siren Chirp Enable (4.2)
One Time Soft Chirp (4.3)
Emergency Disarm (4.4)
Version A
Diagnostic Report
Programming Method
Power On. Within 3 seconds, press button #1 of new
transmitter. Press button #1 of 2
press button #1 of 3
Turn Ignition On/Off 5 times. Press button #1 of new
transmitter. Press button #1 of 2
press button #1 of 3
Turn Ignition on. Press button #2 for 5 seconds
Press #2 before other function buttons.
Turn Ignition On/Off 4 times. Alarm will disarm.
Audible - Chirp
3 chirps
3 chirps
nd
transmitter and then
rd
transmitter.
nd
transmitter and then
rd
transmitter.
3
Visual - LED
Double Flashes
Rapid Flashes
Chirp
1
1
None
2
2
Light
1
1
1
2
2