Config Menu - Lenovo ThinkPad T430 User Manual

• MAC address (Internal LAN)

Config menu

If you need to change the configuration of your computer, select Config from the ThinkPad Setup menu.
The following table lists the Config menu items.
Notes:
• Default values are in boldface. The default settings are already optimized for you. If you consider
changing the computer configuration, proceed with extreme caution. Setting the configuration incorrectly
might cause unexpected results.
• On each submenu, press the Enter key to show selectable options and select a desired option, or type
desired values from the keyboard directly.
• Some items are displayed on the menu only if the computer supports the corresponding features.
Table 5. Config menu items
Menu item
Network
116
User Guide
Submenu item
Wake On LAN
Ethernet LAN Option ROM
(for Legacy Only boot
mode or Both with Legacy
first)
UEFI IPv4 Network Stack
(for UEFI Only boot mode
or Both with UEFI first)
Value
• Disabled
• AC only
• AC and Battery
• Disabled
• Enabled
• Disabled
• Enabled
Comments
Enable the system to power
on when the Ethernet
controller receives a magic
packet (a special network
message).
If you select AC Only,
Wake on LAN is enabled
only when the ac power
adapter is attached.
If you select AC and
Battery, Wake on LAN is
enabled with any power
sources.
Notes:
• AC power is required
with magic packet type
Wake on LAN.
• The Wake on LAN
function does not
work when a hard disk
password is set.
Load the Ethernet LAN
Option ROM to enable
startup from an integrated
network device.
Enable or disable IPv4
(Internet Protocol Version 4)
network stack for the UEFI
environment.