Led Designations - NETGEAR GS728TXS Hardware Installation Manual

Power, Fan, and
Stack Master LEDs
Stack ID LED
Link/Act Mode
Power
Green=Link at 1G
Fan
Yellow=Link at 10/
100M
Stack
Master
ID
Reset Factory
Defaults
Factory
Defaults button
Reset button
Figure 4. GS752TXS front panel
The front panel contains the following:
• 48 RJ-45 connectors for 10/100/1000-Mbps autosensing Gigabit Ethernet switching
ports.
• Four dedicated 1000 Mbps/10Gbps SFP+ Gigabit Ethernet switching ports. Up to two of
these ports (ports 51 and 52) can alternatively be used as stacking ports.
• Reset button to restart the device.
• Recessed Factory Default button to restore the device back to the factory defaults.
• Link, Speed, and ACT LEDs for each port.
• Power, Fan, Stack Master, and Stack ID LEDs.
The following figure illustrates the smart switch back panel.
Kensington Lock™ slot
Figure 5. Back panel
The back panel contains a power connector.

LED Designations

This section describes the LEDs on the smart switch.
GS728TXS/GS752TXS Smart Switch
Link/Speed/ACT LEDs
10/100/1000 Ethernet ports
15
1000M/10G
SFP ports
SFP
+
Green=10G Link Yellow=1G
Blink=ACT
Power connector