Network Adapter Cards; Configuration; Switch Integrity; Autonegotiation - NETGEAR GS728TXS Hardware Installation Manual

Hide thumbs Also See for GS728TXS:

Table of Contents

GS728TXS/GS752TXS Smart Switch

Network Adapter Cards

Ensure that the network adapter cards installed in the computers are in working condition and

the software driver has been installed.

If problems occur after you alter the network configuration, restore the original connections

and determine the problem by implementing the new changes, one step at a time. Ensure

that cable distances, repeater limits, and other physical aspects of the installation do not

exceed the Ethernet limitations.

If necessary, verify the integrity of the switch by resetting the switch. To reset the switch,

remove the AC power from the switch and then reapply AC power. If the problem continues,

contact NETGEAR technical support. In North America, call 1-888-NETGEAR. If you are

outside of North America, refer to the support information card included with your product.

The RJ-45 ports negotiate the correct duplex mode, speed, and flow control if the device at

the other end of the link supports autonegotiation. If the device does not support

autonegotiation, the switch determines only the speed correctly, and the duplex mode

defaults to half-duplex.

Table of Contents

Gs752txs