Assembly - Ariens Professional 32 - 12 Volt Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.
PACKAGE CONTENTS
2
4
1. Sno-Thro Unit
2. Discharge Chute
3. Chute Rod
4. Literature Pack
Figure 3

ASSEMBLY

Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16" and/or Adjustable Wrench
• Tire Gauge
• Socket, 3/4"
• Torque Wrench (optional)
ASSEMBLY
3
Unfold Handlebar
(Figure 4)
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Loosen the hardware on the shift rod.
3. Put the speed selector lever in the
second reverse position.
4. Rotate the handlebars into operating
position.
IMPORTANT: Be careful not to damage cable
spring hooks when rotating handlebars
upward.
5. Install and tighten all hardware on the
1
handlebar assembly and shift rod.
1. Handlebar Hardware
2. Shift Rod Hardware
3. Shift Rod
4. Speed Selector Lever
NOTICE: The handlebar has two height
positions. Adjust the handlebar height to
provide better operator comfort. See
Handlebar Height on page 27.
6. Check tension on auger and traction
clutch cables.
IMPORTANT: Cables should not be slack or
under tension. Adjust as necessary.
EN - 10
3
1
2
Figure 4
4