Ariens Hydro Pro Track 32 Manual page 32

Check Attachment Brake
(Figure 28)
1. With the clutch lever disengaged, brake
pad must contact attachment belts. With
clutch lever engaged, brake pad must be
more than 1,6 mm from belts. If there is
more than 1,6 mm gap, go to Check Belt
Finger Clearance on page 31. If there is
less than 1,6 mm gap, go to step 2.
2
1
Minimum of 1,6 mm.
1. Brake Arm and Pad
2. Attachment Pulley
Figure 30
2. If there is less than 1,6 mm gap between
brake pad and belt, loosen idler
adjustment nut, and move idler away
from belt.
3. Position idler to achieve a 1,6 mm
minimum brake pad gap and a 12,7 –
22,2 mm gap between the plastic roller
and the frame.
IMPORTANT: If adjustments cannot be
brought into specified ranges see your Dealer
for repairs.
Check Belt Finger Clearance
(Figure 29)
1. With clutch lever engaged, the belt
finger located opposite the belt idler
must be less than 3 mm from belts, but
not touching the belts.
To adjust belt finger, loosen the bolts and
move the finger to the proper position.
Tighten the bolts and recheck the belt
finger clearance.
2. Replace the belt cover and tighten
hardware.
Check belt finger clearance here. With the
attachment clutch engaged, there should
be less than 3 mm clearance between the
belts and the belt finger. The belt finger
should not touch the belts.
1. Mounting Hardware
2. Belt Finger
TRACTION DRIVE CLUTCH
OS7201
ADJUSTMENT
1. Loosen jam nut on traction cable
adjustment barrel. Turn adjustment
barrel down to shorten cable and
remove all cable slack.
ATTACHMENT DRIVE BELTS
REPLACEMENT
(Figure 30)
Remove old attachment drive belts
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Loosen hardware securing belt cover to
unit (Figure 30).
NOTE: Do NOT completely remove the
hardware from unit.
3. Remove belt cover.
4. Remove chute gear cover.
5. Remove hair pin in front of chute gear
assembly and slide the discharge chute
rod rearward.
IMPORTANT: Disconnect chute lock cable
and deflector cable.
6. Remove belt finger (Figure 29).
IMPORTANT: Use care when rotating the belt
fingers. DO NOT bend belt fingers out of
shape.
EN - 32
1
2
Figure 31