Ariens Hydro Pro Track 32 Manual page 31

1
2
3
1. Attachment Clutch Cable
2. Adjustment Barrel
3. Jam Nut
Figure 27
5. With the attachment clutch disengaged,
check that the attachment idler arm
lightly touches the frame (Figure 26).
6. Tighten jam nut on the adjustment
barrel.
\
With the attachment clutch disengaged,
check the attachment idler arm position
here. The attachment idler arm should
lightly touch the frame.
Figure 28
Check Attachment Idler Arm Roller
Clearance
(Figure 27)
NOTE: It will be difficult to check the
measurement inside the frame. Use a 12,7
mm minimum spacer as a gauge to check the
clearance between the roller and the frame.
1. Place the unit into the service position.
Remove the bottom cover.
2. With the clutch lever engaged, check the
clearance between the frame and plastic
roller on the lower end of the attachment
OS7185
idler arm (Figure 27).
OS7191
• If roller is 12,7 – 22,2 mm from frame,
no further adjustments are required.
• If roller is less than 12,7 mm from
frame, loosen idler adjustment nut and
move idler closer to the belt. Tighten
adjustment nut and recheck the roller
clearance.
• If roller is more than 22,2 mm from
frame, loosen idler adjustment nut and
move idler away from the belt. Tighten
adjustment nut and recheck roller
clearance.
Some components removed for
4
Roller should be 12,7 – 22,2 mm from the
frame when the attachment clutch is
engaged.
1. Idler Adjustment Nut
2. Attachment Idler Arm
OS7196
3. Roller
4. Frame
EN - 31
clarity of illustration.
1
2
3
Figure 29
OS7189