Ariens Hydro Pro Track 32 Manual page 29

To raise or lower the handlebar:
1. Place unit in service position (see
Service Position on page 24).
2. Remove bottom cover.
3. Remove top mounting bolts from the
handlebars and adjust the handlebar up
or down as needed until the handlebar
mounting holes align with holes in unit
frame.
4. Secure handlebar to frame with
hardware removed in step 3 using the
different hardware locations shown in
Figure 23.
1
4
5
1. Upper Position
2. Lower Position
3. Handlebar
4. Upper Mounting Bolt
5. Lower Mounting Bolt
Figure 23
5. Check and adjust speed selector. See
Speed Selector Adjustment on page 30.
6. Check and adjust auger and traction
clutch cables. See Attachment
Clutch/Brake Adjustment on page 30
and Traction Drive Clutch Adjustment on
page 32.
7. Re-install bottom cover.
REMOTE DEFLECTOR CONTROL
(Figure 24)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control.
2
1
3
3
5
OS7155
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket underneath the dash panel
(Figure 24).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
2
4
1
1. Adjusting Nuts
2. Cable Support Bracket
EN - 29
2
Figure 24