Setting The Clock; Setting The Alarm Time - Grundig Sonoclock SC 5300 User Manual

SETTINGS __________________________

Setting the clock

When you switch on the device for the first time, the time flashes in the
display to indicate that you must set the clock. The same thing applies after
a power failure, or if the device has been unplugged and no back-up
batteries have been inserted.
Press and hold down »TIME«.
1
Press »HOUR« briefly to set the hours step-by-step or hold it down to
2
run through the hours quickly.
MIN
3 Press » « briefly to set the minutes step-by-step or hold it down to
run through the minutes quickly.
Note:
When the minute display changes from »59« to »00«, this does not
affect the hour display.
Release »TIME« to conclude the setting.
4
– Display: the current time.

Setting the alarm time

1 Press and hold down »ALARM«.
– Display: the last alarm time set.
2 Press »HOUR« briefly to set the hours step-by-step or hold it down to
run through the hours quickly.
Press » MIN « briefly to set the minutes step-by-step or hold it down to
3
run through the minutes quickly.
4 Release »ALARM« to conclude the setting.
5 Use the slide switch
side of the device) to set the alarm signal you require (»
station, »e« = signal tone).
– Display: the »ALARM
alarm setting is activated.
– The device switches on at the set alarm time with the selected alarm
signal.
•
9
»RADIO
•
« LED lights up red, which means the
e
ALARM« (on the left
« = radio
15 15