Removable Oven Door - GE JHP60G Use And Care Manual

Plug-In Surface Units
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, the plug-in surface
units are removable.
[
RECEPTACLE ,
MEDAILION
I TERMINALS
I CHROME-PLATED
SPIDER
DRIP ~tWRING
/"
w
SPIOER
To remove
Be sure the control for the sur-
face unit is on OFF and the coils
are cool before removing the
Calrod@ unit.
Raise the unit coil opposite the
receptacle. Lift about one inch
above the trim ring and pull away
from the receptacle.
After removing the plug-in sur-
face unit, lift drip pan/ring to clean
under the unit.
To clean:
Wipe around the edges of the
surface unit opening in the range
To replace:
. Place drip pan/ring in the surface
unit cavity found on top of the
range. Line
up
the drip pan so the
unit receptacle can be seen.
Insert the terminals of the plug-in
unit through the opening in the drip
pan/ring and into the receptacle.
Guide the surface unit into place
so it fits evenly and locks snugly
into the receptacle or trim ring.
NOTE: If your range has separate
trim rings, the drip pan must be
under the trim ring.
Do not attempt to clean, adjust, or
in any way repair the plug-in recep-
tacle. If liquid should spill and col-
lect inside the receptacle, call for
service.
Removable Oven Door
TO REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
TO REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place.
top. Clean the area below. Rinse all
washed areas with a damp cloth or
sponge.
26