Weider Pro 2000 User Manual page 8

4. Slide ten Weights (15) onto the Weight Guides
(10), with the slot for the Weight Pin (not shown)
on the bottom and on the side facing away from
the Upright (3).
Insert the Weight Tube (12) into the Weights (15).
Lubricate the indicated holes in a Weight (15)
with grease. Slide the Weight onto the Weight
Guides (10).
5. Attach the Top Frame (4) to the Upright (3) with
two M8 x 68mm Bolts (63) and two M8 Nylon
Locknuts (69). Do not tighten the Nylon
Locknuts yet.
Attach the Top Frame (4) between the Weight
Guides (10) with an M10 x 155mm Bolt (62), two
M10 Washers (70), and an M10 Nylon Locknut
(68).
Tighten the Nylon Locknuts (68, 69) used in
steps 2 and 5.
6. Attach the Seat Frame (8) to the Upright (3) with
an M8 x 70mm Carriage Bolt (86) and an M8
Knob (82).
Attach the Bumper (75) to the Seat Frame (8)
with an M4 x 19mm Self-tapping Screw (76) and
an M4 Washer (77).
4
5
4
63
3
6
76
75
77
8
10
Lubricate
15
3
12
15
10
62
70
70
68
69
3
86
8
82