Adjustments - Weider Pro 2000 User Manual

ADJUSTMENTS

This section explains how to adjust the weight system. Refer to the accompanying exercise guide to see the cor-
rect form for each exercise.
Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immediate-
ly. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
ATTACHING THE LAT BAR
Attach the Lat Bar (31) to the High Cable (50) with a
50
Cable Clip (33). Note: The Lat Bar can be attached to
the Low Cable (not shown). Remove the Lat Bar
6
when performing exercises that do not require it.
33
39
USING THE Butterfly Arms
To do press arm exercises, push the Press Frame
Lock (39) to the position shown to lock the Right and
31
Left Arms (6, 7). To do fly exercises, lift the Press
7
Frame Lock until the Press Arms are free.
CHANGING THE WEIGHT SETTING
To change the weight setting, insert a Weight Pin (16)
16
under the desired Weight (15) until the bent end of
the Weight Pin touches the Weights. Turn the bent
end downward. Note: Due to the cables and pul-
15
leys, the amount of resistance at each exercise
station may vary from the weight setting. Use the
WEIGHT RESISTANCE CHART on page 18 to find
the approximate amount of resistance at each
weight station.
REMOVING THE SEAT
Disconnect the Low Cable (48) from the Chain (83).
Remove the M8 Knob (82) and the M8 x 70mm
3
86
Carriage Bolt (86). Lift the Seat Frame (8) off the pin
on the Upright (3).
Pin
8
48
83
17