Weider Pro 2000 User Manual page 11

14. Wrap the High Cable (50) over a 90mm Pulley
(34). Attach the Pulley and two Finger Guards
(35) to the Top Frame (4) with an M10 x 46mm
Bolt (53) and an M10 Nylon Locknut (68).
Repeat this step with another 90mm Pulley
(34), two Finger Guards (35), an M10 x 46mm
Bolt (53), and an M10 Nylon Locknut (68).
15. Attach the end of the High Cable (50) to the
Small "U"-bracket (11) with an M8 Washer (71)
and an M8 Nylon Locknut (69). Note: Do not
completely tighten the Nylon Locknut; it
should be threaded onto the Cable so that
two threads show past the Nylon Locknut,
as shown in the inset drawing.
Attach the Small "U"-bracket (11) to the Weight
Tube (12) with an M8 x 45mm Bolt (60) and an
M8 Nylon Locknut (69). Do not overtighten
the Nylon Locknut; the Weight Tube must
pivot easily in the Small "U"-bracket.
16. Locate the Press Cable (49). Slide the Cable
onto the hook on the Left Arm (7).
17. Apply grease to an M10 x 78mm Bolt (54).
Attach the Pulley Arm (38) to the Upright (3)
with the Bolt and an M10 Nylon Locknut (68).
Do not overtighten the Nylon Locknut; the
Pulley Arm must pivot easily.
Wrap the Press Cable (49) over a 90mm Pulley
(34). Attach the Pulley, a Cable Trap (36), an
M10 Washer (70), and two Finger Guards (35)
to the indicated side of the Pulley Arm (38) with
an M10 x 52mm Bolt (52) and an M10 Nylon
Locknut (68). Make sure that the Cable Trap
is oriented to hold the Cable in the groove
of the Pulley.
53
14
35
15
69
12
16
17
3
11
35
4
35
34
50
50
60
11
71
69
50
11
69
Hook
49
7
54 35
38
36
52
68
35
34
70
49
68