Weider Flex 8960 User Manual page 8

8. Press two 40mm x 50mm Inner Caps (41) into
the ends of the Cross Frame (11).
Orient the Cross Frame (11) as shown, with the
welded tube near the top. Attach the Cross Frame
to the Upright (3) with two M10 x 105mm
Carriage Bolts (73), two M10 Washers (75), and
two M10 Nylon Locknuts (76).
9. Press a 40mm x 50mm Inner Cap (41) into the
top of the Front Leg (6). Press the Front Leg Foot
(27) onto the bottom of the Front Leg. Note that
the front of the Front Leg Foot is taller and
slants more than the back.
Press a 40mm x 50mm Inner Cap (41) into the
end of the Bench Frame (5).
Attach the Bench Frame (5) to the Front Leg (6)
with two M10 x 57mm Carriage Bolts (61) and
two M10 Nylon Locknuts (76). Do not tighten the
Locknuts yet.
10. Lubricate the M10 x 80mm Bolt (66) with grease.
Attach the Bench Frame (5) to the Upright (3)
with the Bolt and an M10 Nylon Locknut (76) at
the indicated hole. Do not overtighten the
Locknut; the Bench Frame must be able to
pivot easily.
Tighten the Knob (30) into the Upright (3) and the
Bench Frame (5).
11. Attach the Leg Lever Bumper (55) to the Front
Leg (6) with the M4 x 25mm Screw (56).
Press two 45mm Square Inner Caps (42) into the
ends of the Leg Lever (7).
Lubricate an M10 x 70mm Bolt (64) with grease.
Attach the Leg Lever (7) to the Front Leg (6) with
the Bolt and an M10 Nylon Locknut (76). Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
8
76
Welded
75
Tube
41
9
41
10
76
11
6
76
8
41
75
3
11
5
41
76
6
Back
3
30
Lubricate
66
Hole
64
Lubricate
42
7
55
56
42
73
61
27
5