Weider Flex 8960 User Manual page 12

23. Have a second person lift the Top Weight (not
shown) to create slack in the Long Cable (80).
Slide one end of the Cable through the Swivel
Arm (22). Make sure the Cable is on the indi-
cated side of the rod in the Swivel Arm.
Wrap the Long Cable (80) around a Large Pulley
(28). Attach the Pulley and a Arm Pulley Cover
(87) to the Swivel Arm (22) with an M10 x 45mm
Bolt (2) and an M10 Nylon Locknut (76).
24. Locate the Bench Cable (32). It has three ends,
two that are the same length, and a third that is
shorter.
Route the short end of the Bench Cable (32)
through the hole in the Front Leg (6), and attach it
inside the slot in the Leg Lever (7) with an M10 x
62mm Bolt (63), two M10 Washers (75), and an
M10 Nylon Locknut (76).
25. Wrap the Bench Cable (32) under a Large Pulley
(28). Attach the Pulley and a pair of Pulley
Covers (29) inside the hole in the Front Leg (6)
with an M10 x 65mm Bolt (79), two 8mm Spacers
(52), two M10 Washers (75), and an M10 Nylon
Locknut (76). Make sure that the small tabs on
the Pulley Covers are on the bottom.
Slide the two free ends of the Bench Cable (32)
onto the eyebolt welded to the bottom of the
Bench Frame (5).
26. Locate the two Short Cables (33). Wrap a Short
Cable over a Large Pulley (28). Attach the Pulley
and a pair of Pulley Covers (29) to a Pulley
Housing (21) with an M10 x 50mm Bolt (71) and
an M10 Nylon Locknut (76). Make sure that the
small tabs on the Pulley Covers are on the
bottom.
Repeat this step with the other Short Cable
(33).
23
2
22
76
24
32
76
25
Eyebolt
32
29
Small
Tab
26
29
Small
Tab
12
Rod
28
80
87
6
7
63
75
75
6
5
75
29
28
52
52
75
76
76
21
71
29
28
33
79