Weider Flex 8960 User Manual page 13

27. Press two 19mm Round Inner Caps (78) into the
ends of a Pad Tube (89). Slide the Tube into the
hole in the Leg Lever (7). Slide two Foam Pads
(26) onto the Pad Tube.
Attach the other Pad Tube (89) to the Front
Leg (6) in the same manner.
28. Attach the "FLEX 8960" exercise decal to the
Upright (3) and the Top Upright (4). The decal
should be centred on the Upright and Top
Upright, and the top of the decal should be six
inches below the Top Frame (9). Be careful
not to wrinkle the decal.
Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
29.
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull the long cable a few times to be sure that it moves smoothly over the
pulleys. If the cable does not move smoothly, find and correct the problem. IMPORTANT: If the cables are
not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM
on page 17 for proper cable routing.
27
6
89
26
78
28
6"
13
78
26
7
89
9
4
3