TP-Link TL-WDR3500 User Manual page 25

5GHz - This band is less crowded and is used for time-sensitive music, video streaming

or gaming. Using this band can avoid interference with 2.4GHz networks or noisy
devices like cordless phones and microwave ovens.
6. Configure the basic parameters for 2.4GHz wireless network in the following screen as
shown in Figure 3-12, and then click Next.
Wireless Radio - Displays whether the wireless function is enabled or not.

Wireless Network Name - Also called the SSID (Service Set Identification). Enter a

value of up to 32 characters. The same name must be assigned to all wireless devices
in your network. The default SSID is set to be TP-LINK_2.4GHz_XXXXXX. This value is
case-sensitive. For example, TEST is NOT the same as test.
Region - Select your region from the drop-down list. This field specifies the region

where the wireless function of the Router can be used. It may be illegal to use the
wireless function of the Router in a region other than one of those specified in this field.
If your country or region is not listed, please contact your local government agency for
assistance.

Note:
Limited by local law regulations, version for North America does not have region
selection option.
Band - This field displayed the operating frequency being configured.

Mode - This field determines the wireless mode which the Router works on.

TL-WDR3500
Figure 3-12 Quick Setup – Wireless
- 15 -
N600 Wireless Dual Band Router