Programming The Tax Rate; Single Fixed Percentage Tax Rate - Royal 425cx Instruction Manual

__________________________________________________________________
TO PROGRAM A FIXED TAX RATE:
"PRG" + Tax 1 - 4 + [Tax Shift] + Tax Rate (4 Digit #) + (Amt/Tend/TOTAL)
Note: You can program up to 4 Tax Rates or just 1. The following steps allow you to set up 1 or up to 4. Remember, when you
determine a department's tax status, at that point, you identify the tax rate you want for that department.
If you make a mistake between steps 2 and 4, press the Clear [C] key and start again at step 2.
1. If needed, enter the program mode: Move the Control Switch to the "PRG" position. If a security code has been
assigned, enter the number and press the [CHARGE] key now. If not, continue with Step #2.
2. Enter (1 - 4) , 1 through 4 being the Tax Rate identifier.
3. Press [Tax shift] key
4. Enter the Tax Rate. Up to 5 digits can be used. You MUST enter three digits after the desired decimal place. For
example, to enter 5.5%, type [5500]; to enter 7%, type [7000]; to enter 10%, type [10000].
Note: If you want to set up another Tax Rate, return to step 2. When you are finished setting Tax Rates, go to step 5 to
complete the procedure.
5. Press the [Amt Tend/TOTAL] key.
Continue with other programming or move the Control Switch out of the Program mode.
Example: Set a tax rate of 5.5%:
1. If needed, move the Control Switch to the Program mode (PRG).
2. Enter [5500] + the [Amt Tend/TOTAL] key.
(Recommended For Most Applications)
21
TAX RATE
(Continued)