Weider 8525 User Manual page 7

4. Press two 2" Square Inner Caps (27) into the indi-
cated ends of the Top Frame (55). Press two
1 3/4" Square Inner Caps (44) into the ends of
the crossbar on the Top Frame. Press two Round
Inner Caps (78) into the top of the crossbar.
5. Attach the Top Frame (55) to the Front Upright
(42) with two 5/16" x 2 3/4" Bolts (11), two 5/16"
Washers (8), and two 5/16" Nylon Locknuts (3).
Attach the upper ends of the Weight Guides (62)
to the Top Frame (55) with a 5/16" x 6" Bolt (60)
and a 5/16" Nylon Locknut (3).
Tighten the 5/16" Nylon Locknuts (3) used in
steps 2 and 5.
Arm Assembly
6. Press two 1" x 7/8" Plastic Bushing (75) onto the
welded spacers on the Press Frame (17). Slide
the Press Frame into place on the Base (4) as
shown. Note: This will be a tight fit. The Plastic
Bushings should fit onto each end of the indi-
cated tube in the Base.
Lubricate the 3/8" x 8" Bolt (59) with grease.
Attach the Press Frame (17) to the Base (4) with
the Bolt and a 3/8" Nylon Locknut (21). Do not
overtighten the Locknut; the Press Frame
must be able to pivot easily.
7. Press a 1 3/4" Square Inner Cap (44) into the top
of a Press Arm (46). Press two 1" Round Inner
Caps (49) into the ends of the handle on the
Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16" x 2 1/2" Bolts
(22) and two 5/16" Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
4
44
27
Crossbar
5
55
6
17
21
Welded
Spacer
75
4
7
49 44
46
3
17
7
27
55
78
44
11
8
8
3
60
3
62
42
Lubricate
Tube
49
46
22
59