Weider 8525 User Manual page 10

15. Wrap the Long Cable (23) around a "V"-Pulley
(6). Attach the "V"-Pulley and a Long Cable Trap
(50) to the indicated bracket on the Front Upright
(42) with a 3/8" x 2 1/2" Bolt (7) and a 3/8" Nylon
Locknut (21). Make sure that the Long Cable
Trap is positioned to hold the Cable in place.
16. Route the Long Cable (23) around a "V"-pulley
(6). Attach the "V"-pulley and a Long Cable Trap
(50) to the Left Arm (47) with a 3/8" x 2 1/2" Bolt
(7) and a 3/8" Nylon Locknuts (21). Make sure
that the Long Cable Trap is positioned to hold
the Cable in the groove of the "V"-pulley.
Repeat this step with the Right Arm (48).
17. Note: The 3 1/2" Pulley (15) in this step has
been preassembled. It is shown exploded in
this drawing for clarity.
Route the Long Cable (23) around the 3 1/2"
Pulley (15) attached to the Pulley Bracket (20).
Make sure that the Cable is in the groove of
the Pulley and that the Cable Trap (66) is
turned to hold the Cable in place. Tighten the
3/8" x 2" Bolt (12) and the 3/8" Nylon Locknut (21).
Make sure that the 5/16" x 5" Bolt (not shown) is
properly tightened and that the Pulley Bracket
(20) can move freely.
18. Attach a 3 1/2" Pulley (15) and a Cable Trap (66)
to the indicated hole in the Long "U"-bracket (57)
with a 3/8" x 2" Bolt (12) and a 3/8" Nylon
Locknut (21). Make sure that the Cable Trap is
inside of the "U"-bracket.
Route the Long Cable (23) between the 3 1/2"
Pulley (15) and the Cable Trap (66). Make sure
that the Cable is in the groove of the Pulley
and that the Cable and Pulley move smoothly.
15
16
48
47
17
18
15
12
10
6
50
21
23
42
7
23
50
6
47
21
21
66
15
12
20
23
23
66
21
57
7