Printout Problems; The Font Selected In The Application Software; Will Not Print; Some Or All Of The Printout Is Garbled - Epson AcuLaser C8600 Reference Manual

Printout problems

The font selected in the application software will
not print
Cause
You may use the printer fonts
substituted for specified
TrueType fonts.
The selected font is not
supported by your printer.

Some or all of the printout is garbled

Cause
The interface cable may not be
plugged in securely.
You may not be using the
correct interface cable.
The emulation setting for the
port may not be correct.
What to do
In the printer driver, choose the Print
TrueType fonts as bitmap radio button
in the Extended Settings dialog box.
Make sure that you have installed the
correct font. See "Available Fonts" on
page 363 for more information.
What to do
Make sure that both ends of the
interface cable are plugged in securely.
If you are using the parallel interface,
make sure that the cable is a
double-shielded, twisted-pair interface
cable no more than six feet in length.
If you are using the USB interface, use a
Revision 1.1 compliant cable.
Specify the emulation mode by using
the printer's control panel menus. See
"Emulation Menu" on page 179.
Troubleshooting
10
10
10
10
10
10
10
10
10
10
10
10
301