Power Button Board - HP Pavilion g7 Maintenance And Service Manual

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
Remove the power button board:
1. Turn the top cover upside down, with the front toward you.
2. Release the power button board cable from the clip (1) built into the top cover.
3. Remove the Phillips M2.5×3.0 screw (2) that secures the power button board to the top cover.
4. Lift the right side of the power button board (3) until it rests at an angle.
5. Remove the power button board and cable by sliding the board up and to the right at an
angle (4).
Reverse this procedure to install the power button board and cable.
Battery on page 37), and then remove the following components:
Optical drive on page
Hard drive or SSD on page
Keyboard on page 47)
Top cover on page 50)
39)
41)
Component replacement procedures
Spare part number
640212-001
53