Frequently Used Menu Operations; Tuner; Basic Operations - Pioneer FH-X700BT Operation Manual

Operating this unit
FM STEP (FM tuning step)
Normally, the FM tuning step employed by seek tun-
ing is 50 kHz. When AF or TA is on, the tuning step
automatically changes to 100 kHz. It may be prefer-
able to set the tuning step to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during manual
tuning.
1 Turn M.C. to select the FM tuning step.
50 (50 kHz)—100 (100 kHz)
2 Press M.C. to confirm the selection.
QUIT appears.
5 To finish your settings, turn M.C. to se-
lect YES.
# If you prefer to change your setting again, turn
M.C. to switch to NO. Press to select.
6 Press M.C. to select.
Notes
! You can set up the menu options from the sys-
tem menu. For details about the settings, refer
to System menu on page 17.
! You can cancel set up menu by pressing SRC/
OFF.

Basic operations

Turning the unit on
1 Press SRC/OFF to turn the unit on.
Turning the unit off
1 Press and hold SRC/OFF until the unit turns off.
Selecting a source
1 Press SRC/OFF to cycle between:
TUNER (tuner)—CD (CD player)—USB (USB)/
iPod (iPod)—AUX (AUX)—BT AUDIO (Bluetooth
audio)
Adjusting the volume
1 Turn M.C. to adjust the volume.
CAUTION
For safety reasons, park your vehicle when remov-
ing the front panel.
Note
When this unit's blue/white lead is connected to
the vehicle's auto-antenna relay control terminal,
the vehicle's antenna extends when this unit's
source is turned on. To retract the antenna, turn
the source off.
Frequently used menu
operations
Returning to the previous display
Returning to the previous list (the folder one level
higher)
1 Press
/DIMMER.
Returning to the ordinary display
Canceling the main menu
1 Press BAND/ .
Returning to the ordinary display from the list
1 Press BAND/ .

Tuner

Basic operations
Selecting a band
1 Press BAND/
until the desired band (FM1,
FM2,FM3 for FM or MW/LW) is displayed.
Switching preset stations
1 Press c or d.
! Select PCH (preset channel) under SEEK to use
this function. For details about the settings, refer
to SEEK (left/right key setting) on page 7.
Manual tuning (step by step)
1 Press c or d.
! Select MAN (manual tuning) under SEEK to use
this function. For details about the settings, refer
to SEEK (left/right key setting) on page 7.
Seeking
1 Press and hold c or d, and then release.
You can cancel seek tuning by briefly pressing c
or d.
While pressing and holding c or d, you can skip
stations. Seek tuning starts as soon as you re-
lease c or d.
Section
02
5
En