Using An Aux Source; If An Unwanted Display Appears - Pioneer FH-X700BT Operation Manual

Section
Operating this unit
02
The rear speaker leads output and the RCA output of
this unit can be used to connect a full-range speaker
or subwoofer. Select a suitable option for your con-
nection.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the desired setting.
You can select any one of the options in the fol-
lowing list:
! REAR/SUB.W – Select when there is a full-
range speaker connected to the rear speaker
leads output and there is a subwoofer con-
nected to the RCA output.
! SUB.W/SUB.W – Select when there is a sub-
woofer connected directly to the rear speaker
leads output without any auxiliary amp and
there is a subwoofer connected to the RCA
output.
! REAR/REAR – Select when there is a full-
range speaker connected to the rear speaker
leads output and the RCA output.
If there is a full-range speaker connected to
the rear speaker leads output and the RCA
output is not used, you may select either
REAR/SUB.W or REAR/REAR.
S/W UPDATE (updating the software)
This function is used to update this unit with the lat-
est Bluetooth software. For about Bluetooth software
and updating, refer to our website.
! Never turn the unit off while the Bluetooth soft-
ware is being updated.
1 Press M.C. to display the data transfer mode.
Follow the on-screen instructions to finish updat-
ing the Bluetooth software.
System menu
1 Press and hold SRC/OFF until the unit
turns off.
2 Press and hold SRC/OFF until the main
menu appears in the display.
3 Turn M.C. to change the menu option
and press to select SYSTEM.
4 Turn M.C. to select the system menu
function.
For details, refer to System menu on page
17.
22
En

Using an AUX source

1 Insert the stereo mini plug into the
AUX input jack.
2 Press SRC/OFF to select AUX as the
source.
Note
AUX cannot be selected unless the auxiliary set-
ting is turned on. For more details, refer to AUX
(auxiliary input) on page 18.
Switching the display
Selecting the desired text information
1 Press DISP to cycle between the following:
! Source name
! Source name and clock
If an unwanted display
appears
Turn off the unwanted display using the proce-
dures listed below.
1 Press M.C. to display the main menu.
2 Turn M.C. to change the menu option
and press to select SYSTEM.
3 Turn M.C. to display DEMO OFF and
press to select.
4 Turn M.C. to switch to YES.
5 Press M.C. to select.