11
SERVICE WORK ON THE CHASSIS
11.17
Removing the shock absorber
11.18
Installing shock absorber
Warning
Danger of accidents Modifications to the suspension settings can seriously alter the vehicle's ride behavior.
–
Following modifications, ride slowly at first to get the feel of the new ride behavior.
11.19
Removing the seat
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
601982-11
x
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
101939-10
x
Main work
–
Push the splash protector
to the desired seat height. Mount and tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
101939-11
Screw, bottom shock absorber
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Open quick release
–
Pull back the seat and remove it.
101940-10
and lower the rear wheel with the swingarm as far as possible
1
, push splash protector
2
3
to the side and position the shock absorber according
1
.
3
and raise the rear of the seat.
1
.
2
M6
10 Nm (7.4 lbf ft)
p. 27)
to the side, and remove the shock
.
2
M10
45 Nm
(33.2 lbf ft)
M10
45 Nm
(33.2 lbf ft)
p. 27)
34