How To Use A Preset Program - NordicTrack Cxt 1400 Elliptical User Manual

HOW TO USE A PRESET PROGRAM

Press any button on the console or begin
1
pedaling to turn on the console.
See step 1 on page 15.
Select one of the eight preset programs.
2
To select a preset program, press one of the but-
tons labeled "20 minutes," "30 minutes," or "45
minutes." Note: Each "30 minutes" button can be
used to select two programs.
When a preset pro-
gram is selected, a
profile of the resis-
tance settings of the
program will scroll
across the matrix. In
addition, the program
time will appear in the upper display, and the
maximum resistance setting of the program will
flash in the lower display for a moment.
Press the Start button or begin pedaling to
3
start the program.
Each program is divided into several one-minute
segments. One resistance setting and one pace
setting are programmed for each segment. Note:
The same resistance setting and/or pace setting
may be programmed for two or more consecutive
segments.
The resistance
setting for the first
segment will be
shown in the
flashing Current
Segment column
of the matrix. (The
pace settings are not shown in the matrix.) The
resistance settings for the next several segments
will be shown in the columns to the right.
As you exercise, the Target Pace guide will help
you to keep your pedaling pace near the pace
setting for the current segment. When one of the
"Too Slow" indicators lights, increase your pace;
Current Segment
when the one of the "Too Fast" indicators lights,
decrease your pace; when the "On Pace" indica-
tor lights, maintain your current pace.
Important: The pace settings are intended
only to provide motivation. Your actual pace
may be slower than the pace settings. Make
sure to exercise at a pace that is comfortable
for you.
When only three seconds remain in the first seg-
ment of the program, both the Current Segment
column and the column to the right will flash, a
series of tones will sound, and all resistance set-
tings will move one column to the left. The resis-
tance setting for the second segment will then be
shown in the flashing Current Segment column,
and the resistance of the elliptical exerciser will
change to the resistance setting for the second
segment. Note: If all of the indicators in the
Current Segment column are lit after the resis-
tance settings have moved to the left, the resis-
tance settings may move downward so only the
highest indicators appear in the matrix.
The program will continue until the resistance
setting for the last segment is shown in the
Current Segment column and the last segment
ends.
Note: During the program, you can override the
resistance setting for the current segment, if
desired, by pressing the 1 Step Resistance but-
tons. However, when the next segment begins,
the resistance will change if a different resistance
setting is programmed for the next segment.
If you stop pedaling for several seconds, a tone
will sound and the program will pause. To restart
the program, simply resume pedaling.
17