NordicTrack 9600 Spn Dom Treadmill Manual page 24

Press the ENTER AGE/WT button again to
9
check for system errors.
If there are no system errors, the words NO SYS-
TEM ERRORS will appear in the main display. If a
system error appears, call Customer Care toll-free
at 1-800-201-2109.
Press the ENTER AGE/WT button again and
10
enable or disable the safety key.
To require the use of the safety key with the con-
sole, press the + or – button above the ENTER
AGE/WT button until the words SAFETY KEY EN-
ABLED appear in the main display. To allow the
treadmill to be used without the key, press the + or
– button until the words SAFETY KEY DISABLED
appear. CAUTION: If the safety key is missing
or damaged, call Customer Care toll-free at
1-800-201-2109, Monday through Friday, 8 a.m.
until 5 p.m. Mountain Time.
If you have the Basic console, go to step 15. If
you have the Workout TV console, go to step 11.
Press the ENTER AGE/WT button again and
11
enable or disable the TV.
To make the TV available for use, press the + or –
button above the ENTER AGE/WT button until the
words TV POWER ON appear in the main display.
To prevent the TV from being used, press the + or
– button until the words TV POWER OFF appear.
If you have disabled the TV, go to step 15. If
you have enabled the TV, go to step 12.
Press the ENTER AGE/WT button again and
12
select a cable TV connection or an antenna
connection.
If you are using a cable TV connection, press the +
or – button beside the ENTER AGE/WT button
until the words TV MODE CABLE STATIONS ap-
pear in the main display. If you are using an an-
tenna connection, press the + or – button until the
words TV MODE AIR STATIONS appear.
Press the ENTER AGE/WT button again and
13
program TV channels.
The console has the capability to find and store in
memory all of the valid TV channels in your area.
While the words PRESS CHANNEL UP TO SCAN
TV CHANNELS are scrolling across the main dis-
play, press the CHANNEL + button to start the
channel scanning process.
The console will begin scanning all TV channels. If
no broadcast signal is detected on a channel, the
channel will be skipped; if a signal is detected, a
tone will sound and the channel will be stored in
memory. This process will continue until the high-
est channel is reached. The lowest channel stored
in memory will then appear in the main display.
24