GE Advantium PSB1200BB Installation Instructions Manual page 17

ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN
1 REMOVE PACKAGING AND PARTS
• Remove the drawer from the carton.
• Remove all packing material and tape.
• Open the drawer and remove any parts inside.
• Locate parts.
Assembly Instructions
Screws
(6 required,
2 extra)
2 UNDER-THE-COUNTER (UTC)
MOUNTING BRACKET INSTALLATION
NOTE: For UTC models PSB1200, PSB1201 and
ZSC1201 only.
Open the accessory drawer so you have
A
access to the top bracket.
Remove the three screws securing the top
B
bracket.
Install the new UTC mounting bracket using
C
the screws removed previously.
Close the drawer and proceed with the
D
installation.
Side Supports (2)
Under-the-Counter (UTC)
Mounting Bracket
Color-Matched
Screws
(4 required,
1 extra)
3 ASSEMBLING THE OVEN TO DRAWER
Place storage drawer on a surface with
A
the front of drawer hanging over the edge
of the surface. Not placing the front edge
of drawer over the edge of the surface may
result in damage to the drawer since the front
edge of drawer hangs below the bottom
of drawer.
Place the oven on top of the storage drawer.
B
Make sure that the back and sides of the oven
align with the back and sides of drawer.
NOTE: The bottom of the oven side flanges will
sit directly in front of the top of the storage
drawer side flanges.
17