Rear Wheel - Yamaha TT-R50E Owner's Manual

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
4
3
2
1
5
1. Axle nut
2. Washer
3. Drive chain slack adjusting nut
4. Locknut
5. Drive chain puller
2. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU25080
1
EAU39774
EWA10821
3
1. Brake pedal free play adjusting nut
2. Brake rod
3. Brake camshaft lever
3. Fully loosen the locknut and drive
chain slack adjusting nut on each
end of the swingarm.
4. Lift the rear wheel off the ground
according to the procedure on
page 7-25.
5. Remove the axle nut, washer and
the drive chain puller at the left-
hand side, then pull the wheel axle
out together with the drive chain
puller from the right-hand side.
2
1. Wheel axle
6. Push the wheel forward, and then
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
7-28
remove the drive chain from the
rear sprocket.
7