Presetting The Channels (Manual) - Sharp Aquos LC-15S5H Operation Manual

Presetting the Channels (MANUAL)

I Setting a channel to a desired TV station
Upper control panel
1
Press MENU (PRESET-1) on the upper part of the
LCD TV set for more than 2 seconds to display the
AUTO mode screen.
2
Press MENU (PRESET-1) to display the MANUAL
mode screen.
• Press MENU (PRESET-1) again to change the
MANUAL mode as shown below.
AUTO MANUAL
3
Select the channel position using Channel Select or
CH ( )/( ).
4
Press VOL (–)/(+) (PRESET-2) to locate the
channel you want to preset to the position. Search is
initiated and when a TV signal is received during the
search, the search stops.
5
Repeat steps 3 and 4 above, to preset the channel
positions for other broadcasts, etc.
6
Press MENU (PRESET-1) twice to return to the
normal screen.
NOTE
• System may not have been set correctly, if noise can be heard or
if there is no sound. In such a case, adjust "SOUND SYSTEM".
(See page 14.)
Sound system
LANGUAGE NORMAL SCREEN
I In a weak reception area or under bad reception
conditions
Upper control panel
1
Press MENU (PRESET-1) on the upper part of the
LCD TV set for more than 2 seconds to display the
AUTO mode screen.
2
Press MENU (PRESET-1) to display the MANUAL
mode screen.
3
While the MANUAL mode screen is displayed, press
MENU (PRESET-1) for more than 2 seconds.
The channel position number remains in green.
4
Adjust for good reception using VOL (–)/(+)
(PRESET-2).
5
After finishing the adjustment, press MENU
(PRESET-1) to continue channel presetting.
NOTE
• While the MANUAL mode screen is displayed, press MENU
(PRESET-1).
(The LANGUAGE mode screen will appear.)
Preset (Continued)
13