Presetting The Channels (Manual) - Sharp Aquos LC-20B6M Operation Manual

Presetting the Channels (MANUAL)

■
Setting a channel to a desired TV station:
Upper control panel
4 3
1
Press MENU (PRESET-1) on the upper part of the
LCD TV set for more than 2 seconds to display the
AUTO mode screen.
Sound system
Auto ( B/G )
VHF 1
48.25MHz
2
Press MENU (PRESET-1) to display the MANUAL
mode screen.
• Press MENU (PRESET-1) again to change the
MANUAL mode as shown below.
AUTO MANUAL
3
Select the channel position using Channel Select or
CH ( )/( ).
M a n u a l ( B / G )
V H F 1
4 8 . 2 5 M H z
4
Press VOL (+)/(–) to locate the channel you want to
preset to the position. Search is initiated and when a
TV signal is received during the search, the search
stops.
5
Repeat steps 3 and 4 above, to preset the channel
positions for other broadcasts, etc.
M a n u a l ( B / G )
U H F 5
6 2 3 . 2 5 M H z
6
Press MENU (PRESET-1) to return to the normal
screen.
NOTE
• System may not have been set correctly, if noise can be heard or
if there is no sound. In such case, adjust "Sound system" (See
page 14).
1, 2, 6
LANGUAGE NORMAL SCREEN
■
In a weak reception area or under bad reception
conditions.
Upper control panel
4
1
Press MENU (PRESET-1) on the upper part of the
LCD TV set for more than 2 seconds to display the
AUTO mode screen.
2
Press MENU (PRESET-1) to display the MANUAL
mode screen.
3
While the MANUAL mode screen is displayed, press
MENU (PRESET-1) for more than 2 seconds.
The channel position number remains in green.
4
Adjust for good reception using VOL (+)/(–).
5
After finishing the adjustment, press MENU
(PRESET-1) to continue channel presetting.
NOTE
• While the MANUAL mode screen is displayed, press MENU
(PRESET-1).
(The LANGUAGE mode screen will appear.)
M a n u a l ( B / G )
V H F 1
4 8 . 2 5 M H z
F i n e
U H F 5
6 2 3 . 2 5 M H z
E n g l i s h
Preset (Continued)
1, 2, 3, 5
13