Honda XR125LK Owner's Manual page 110

12/04/20 17:09:55 32KRHA20_110
Front Wheel Installation
(XL125LK)
Reverse the removal procedure.
Install the side collar into the right side
wheel hub.
Position the wheel between the fork legs
and insert the front axle shaft from the
right side, through the right fork leg and
wheel hub.
Make sure that the lug ( ) on the left
fork leg is located in the brake panel.
Tighten the front axle nut to specified
torque.
Front axle nut torque:
44 N·m (4.5 kgf·m , 33 lbf·ft)
Install the brake cable and front brake
adjusting nut.
Adjust the front brake (pages
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not
rotate freely.
Install the speedometer cable securely.
100
If a torque wrench is not used for
installation, see your dealer as soon as
possible to verif y proper assembly.
Improper assembly may lead to loss of
braking capacity.
8
27 28 ).
(8) Lug
(8)