Weber Summit 425 NG Step-By-Step Manual page 10

CHECK FOR GAS LEAKS
(CONTINUED)
Do not use an open flame to check for gas
leaks. Be sure there are no sparks or open
flames in the area while you check for
leaks. This will result in a fire or explosion
which can cause serious bodily injury or
death and damage to property.
WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
You will need: a soap and water solution and a rag or
brush to apply it.
Note: Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
WARNING: Make sure all burner control knobs are
in the OFF position, including the side burner, if the
barbecue has a side burner.
Turn on gas supply.
Check for leaks by wetting the connections with the soap
and water solution and watching for bubbles. If bubbles
form or if a bubble grows there is a leak.
WARNING: Do not ignite burners when leak checking.
a)
Summit 425 or
Summit 450
Figure 17
DANGER
c)
Manifold
d)
Manifold
a)
d)
Manifold
Check:
a) Left valves to manifold connection. Figure 17 (a).
b) Center valves to manifold connection. Figure 17 (b).
(For Summit 625 or 650 only.)
c) Right valves to manifold connection. Figure 17 (c).
d) Gas line to manifold connection. Figure 17 (d)
WARNING: If there is a leak at connection 17 (d),
turn OFF the gas and retighten the fitting with a
wrench and recheck for leaks with soap and water
solution.
If a leak persists after retightening the fitting, turn
OFF the gas. DO NOT OPERATE THE BARBECUE.
Contact your dealer.
10
b)
Manifold
Summit 625 or
Summit 650
Figure 17
c)