Install Bottom Shelves; Install Condiment Holders And Work Surfaces - Weber Summit 425 NG Step-By-Step Manual

INSTALL BOTTOM
SHELVES
For the Summit 425 or 625, place the stainless steel
bottom shelves between the frame supports.
For the Summit 450 and 650, place the bottom rack under
the cart between the frame supports. Lift up one end of
the rack so it clears the crosspiece. Continue to lift until
the opposite end clears the opposite crosspiece. Set the
rack in place on both crosspieces.
Summit 425 or 625
Summit 450 or 650
Figure 12
INSTALL CONDIMENT
HOLDERS AND WORK
SURFACES
You will need: two condiment holders, two stainless steel
work surfaces, and four wing nuts.
Place the condiment holders on the left and right side of
the frame. Figure 13(a). Set the work surfaces over the
condiment holders on both sides of the barbecue. The
studs of the work surface go through the holes in the
top of the condiment holder and through the frame rail.
Thread on the wing nuts on the front and back and
tighten. Figure 13(b).
a)
b)
8
Studs
underneath
work surface
Figure 13