HP R1500 - UPS XR User Manual page 33

4. Disconnect the battery cable from the circuit board located on the right side of the
UPS (1). Unfasten the cable wires from the clasp and remove the wires without
disturbing the pedestal or the user interface (2).
Figure 4-5: Disconnecting the battery cable from the circuit board
5. The battery pack is surrounded by a plastic cover. Unfasten the plastic handle and remove
the battery pack.
Figure 4-6: Removing the battery pack
NOTE: Since UPS R1500 XR spare battery packs include cable wiring, it is not necessary to
disconnect or reuse the wires connected to the old battery pack.
6. Set the used battery pack and the battery wiring aside for proper disposal. Refer to
"Disposing of Used Batteries," in this chapter.
HP Uninterruptible Power System R1500 XR Models User Guide
2
2
WARNING: The UPS R1500 XR battery pack weighs 11 kg (24 lb). Prepare the area and
observe all materials handling procedures for removing the battery pack.
1
Battery Maintenance
4-5