Assembling/Using/Adjusting The Handcycle Rack - Invacare Excelerator Owner's Operator And Maintenance Manual

SECTION 8
ASSEMBLING/USING/ADJUSTING THE HANDCYCLE
RACK (FIGURE 12)
ASSEMBLING THE HANDCYCLE RACK
1. Position the receiver with the bracket facing UP as shown in FIGURE 12.
2. Position the rear wheel bar with the wheel brackets facing up as shown in FIGURE
12.
3. Remove the two (2) large mounting bolts and locknuts from the receiver and set
aside.
4. Remove the two (2) small mounting bolts and locknuts from the receiver bracket
and set aside.
5. Secure the wheel tray to the receiver with the two (2) large mounting bolts and
locknuts.
6. Secure the receiver bracket to the wheel tray with the two (2) small mounting bolts
and locknuts.
7. Remove the two (2) mounting bolts and locknuts from the rear wheel bar and set
aside.
8. Secure the rear wheel bar to the wheel tray with the two (2) mounting bolts and
locknuts.
9. Install the receiver onto the trailer hitch of the vehicle, according to the vehicle
manufacturer's instructions.
USING THE HANDCYCLE RACK
1. Position the handcycle on the rack with the front wheel in the wheel tray bracket.
2. Adjust the handcycle rack so the wheel tray bracket sits against the front wheel and
the rear wheel bar brackets sit against the rear wheels. Refer to ADJUSTING THE
HANDCYCLE RACK in this procedure.
3. Secure the front wheel to the wheel tray bracket using the strap provided.
4. Secure the rear wheels to the rear wheel bar using the straps provided.
Excelerator™Series
44
OPTIONS
Part No. 1056188