Seven (7) Speed Shifter Cable Installation; Seven (7) Speed Shifter Adjustment/Replacement - Invacare Excelerator Owner's Operator And Maintenance Manual

SERVICE PROCEDURES
SECTION 7

SEVEN (7) SPEED SHIFTER CABLE INSTALLATION

(FIGURE 2)
NOTE: This procedure applies to the Excelerator ONLY.
NOTE: The SEVEN (7) SPEED Shifter Cable runs from the RIGHT-SIDE of the FRONT FRAME to
its mounting position on the HAND CRANK Assembly Shaft.
1. Run the cable from the right-side of the fork assembly to mounting position on the
left side just below the hand crank assembly.
2. Attach the seven (7) speed shifter to the hand crank assembly extension.
3. Secure with hardware provided.
Hand Crank
Assembly
Cable
Extension
Shifter
FIGURE 2 - SEVEN (7) SPEED
SHIFTER CABLE INSTALLATION
SEVEN (7) SPEED SHIFTER ADJUSTMENT/
REPLACEMENT
Excelerators are equipped with SHIMANO hubs. If equipped with a SHIMANO hub, it
MUST be serviced and adjusted by a qualified technician.
NOTE: QUALIFIED TECHNICIANS ONLY - Contact Invacare, 1-800-532-8677 for complete
SHIMANO hub instructions.
It is recommended that you take your Excelerator to a qualified technician for any
shifter adjustment.
31
Part No. 1056188 Excelerator™Series