Running Mtcflash On Each Ce - HP NetServer AA 4000 Reference Manual

Running MTCFlash on each CE

Network Server Division
•
Install Endurance Software
•
Kit Number
•
IOP installation
•
Restore Original Installation Parameters
•
IOP in TUPLEx (for IOP1, choose TUPLE1; for IOP2,
choose TUPLE2)
•
Destination directory for IOP Maintenance Mode
•
DoNot Edit Configuration
•
Install the Endurance 4000 online documentation.
•
If you are running Windows NT Server on the IOP, configure the
Network, Service, Server, and Properties to Maximize for
Network Performance.
•
Determine whether the Marathon Datagram Service (MtcDgs) is
installed on your server.
If not, install and bind it using the procedures outlined in the
networking setting.
•
Install the Virtual Network Provider on each IOP.
•
Reboot the IOP and CE operating systems. Upon reboot, the
Virtual Network is enabled on the Endurance 4000 server.
Use the MTCFlash diskette to Flash the MICs on the IOPs.
WARNING
Make sure to complete the flash of the MIC by completely
powering off the NetServer using the power switch. Do not
use the reset button or issue a Ctrl-Alt-Del reboot.
•
Boot the IOPs to Online Marathon mode. Examine the
Marathon Manger while the systems boot to confirm the IOP
status of the IOPs is online.
•
To complete the Marathon software upgrade, you must run
MTCFLASH on both CEs.
•
You will have to temporarily attach a keyboard to the CEs to
complete this task.
Ch 5: System Upgrades
5-13