HP NetServer AA 4000 Reference Manual page 132

HP NetServer AA
Installing the New IOP
7-16
2. Install LAN adapters, MICs, and any other cards, disks and
memory. Make sure to match the removed IOP exactly.
NOTE
For the Ethernet adapter that provides network access -- If you
removed this adapter from the IOP that you are replacing, do not
use it in any other network device other than the new IOP.
Otherwise, it can cause MAC address conflicts.
3. Decide which, if any, disks will be transferred to the new IOP.
When you install those disks, make sure that their new
configuration is identical to the configuration that was used in
the IOP that you are replacing.
4. If you are installing and replacing existing mirrored disks with
new disks:
•
Make sure that the new disk's configuration is identical to its
mirror counterpart on the other IOP.
•
Make sure that the new disk's configuration is identical to
the disk that you are replacing (including the same SCSI bus
number and device ID).
After preparing the new IOP, finish installing the new IOP by
completing the following:
1. If required, fasten the rackmount brackets and install the IOP in
the rack.
2. Attach the following cables to the IOP:
•
The power cord.
•
The MIC cable.
•
The Ethernet cable that connects the IOP to the public
Ethernet network.
•
The IL cable.
•
The video cable, the keyboard, and the mouse.
3. Plug in the power cord.
4. Power up the new IOP.
5. On the SSDL, make sure that the status lights in column 1 and 2
are lit green.
6. If one of these status lights is red or not lit, correct the condition
by checking the cable for tightness.
7. If you installed the IOP boot disk from the IOP that you
replaced, continue with the next step.
8. Otherwise, install Windows NT and Marathon software as
described in previous chapters.
9. This includes:
Hewlett-Packard Company