First Time Setup Wizard; Before You Begin; Enclosure Selection Screen - HP Integrity Superdome 2 16-socket User Manual

4 First Time Setup Wizard

NOTE: The First Time Setup Wizard is used only to configure compute enclosures and Onboard
Administrator network settings. The First Time Setup Wizard does not enable you to set up and
configure partitions.
For information on partition creation and management, see the HP Integrity Superdome 2 Partitioning
Administrator Guide.

Before you begin

Before running the First Time Setup Wizard, complete the following tasks:
1. Install the Onboard Administrator modules.
2. Connect the Onboard Administrator modules to the network.
3. Complete the Insight Display installation wizard. You must at least configure the active Onboard
Administrator IP address.
4. Run the Insight Display installation.
Logging on to Onboard Administrator
For information on logging on to the Onboard Administrator, see
Administrator GUI" (page
The first time you log on, the Onboard Administrator automatically runs the First Time Setup Wizard.
To navigate the setup wizard, click the Next button to save your changes and go to the next step.
Click the Skip button if you want to leave the step without saving the changes.
You can return to previous wizard steps by selecting them in the left tree view. You can also run
the wizard again at any time by selecting it from the Wizards menu.

Enclosure Selection screen

The Enclosure Selection screen displays all discovered enclosures and selects the active enclosure,
the enclosure you are signed in to by default. The check box beside each enclosure enables you
to select or clear that enclosure. Selecting the check box beside All Enclosures toggles the check
box for all enclosures.
Click the Refresh Topology button to update the rack topology information. When you select Refresh
Topology, the Enclosure Selection screen switches to the Linked Mode and all linked enclosures
appear.
15).
"Logging on to the Onboard
Before you begin 41