Brocade Communications Systems Brocade BladeSystem 4/24 User Manual page 584

18
Adding tape pools
A tape pool can be identified by either a name or a number, but not both. Tape pool names and
numbers must be unique within the encryption group. When a new encryption group is created, any
existing tape pools in the switch are removed and must be added.
1. Select Configure > Encryption from the menu bar.
2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu
3. Select an encryption group from the tree, and select Group > Tape Pools from the menu bar, or
FIGURE 210
FIGURE 211
4. Specify the Tape Pool Label Type. Tape pools can be identified by either a name or a number,
5. Enter a name for the tape pool. If you selected Number as the Tape Pool Label Type, the name
550
The Encryption Center dialog box displays.
bar.
The encryption groups display in the Encryption Devices table.
right-click the encryption group and select Tapepools.
The Add Tape Pool dialog box displays. The Name tape pool label type is the default; however,
you can change the tape pool label type to its number by selecting Number, shown in
Figure 211.
Add Tape Pool by name dialog box
Add Tape Pool by number dialog box
shown in Figure 210 and
must match the tape pool label or tape ID/number that is configured on the tape
backup/restore application.
Figure 211.
DCFM Professional Plus User Manual
53-1001774-01