Cee Configuration Tasks; Minimum Cee Configuration For Fcoe Traffic - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

CEE configuration tasks

The CEE Configuration dialog box enables you to perform the following tasks:
•
•
•
•
Instructions for performing the CEE configuration tasks shown in
following sections:
•
•
•
•
•
•

Minimum CEE configuration for FCoE traffic

You must complete the following proceudres to to create the basic configuration of CEE for FCoE
traffic.
NOTE
The first two procedures in this section can be completed as a single procedure. They were broken
into two separate procedures for clarity.
DCFM Professional Plus User Manual
53-1001774-01
Edit CEE ports for a selected switch. You can also add a link aggregation group (LAG) if a single
switch is selected.
Edit a switch or port and configure the following CEE policies:
NOTE
Access Control List and Spanning Tree Protocol can also be set at the LAG level.
•
QoS
•
LLDP-DCBX
•
Access Control List
•
Spanning Tree Protocol
•
802.1x
Enable or disable a LAG or CEE port.
Display performance statistics for CEE ports.
"Link aggregation groups"
"QoS configuration" on page 373
"LLDP-DCBX configuration"
"Access Control List configuration"
"Spanning Tree Protocol configuration"
"802.1x authentication" on page 398
on page 362
on page 382
on page 388
on page 393
Figure 106 are detailed in the
15
355