Deleting A Zone Configuration; Deleting An Offline Zone Database - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

22

Deleting a zone configuration

5. Click Yes on the confirmation message.
6. Click OK or Apply on the Zoning dialog box to save your changes.
Deleting a zone configuration
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Select one or more zone configurations in the Zone Configs list that you want to delete, then
5. Click Yes to delete the selected zone configuration.
6. Click OK or Apply to save your changes.

Deleting an offline zone database

For pure EOS fabrics in McDATA Fabric Mode (InteropMode 2) or McDATA Open Mode (InteropMode
3) and for mixed Fabric OS and M-EOS fabrics in McDATA Open Mode, you cannot delete the last
available offline zone database, because only offline zoning is supported for these fabrics.
1. Select Configure > Zoning > Fabric.
2. Select an FC fabric from the Zoning Scope list.
642
To selected zone alias is deleted from the Alias list.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
right-click and select Delete.
A message box displays asking you to confirm the deletion.
The message box closes and, when successful, the selected zone configurations are removed
from the Zone Configs list.
NOTE
If you select "Do not show me this again." on the confirmation message box, the next time you
delete a zone configuration, it will be deleted without requesting confirmation from you. If you
delete something in error, click Cancel on the Zoning dialog box to exit without saving changes
since the last operation (Apply or Activate). When you reopen the dialog box, the zone
configuration is restored.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
databases for the selected entity.
DCFM Enterprise User Manual
53-1001775-01